1. Five battery charge modes of power system can be
programmed by CSU :
- Float Charge Mode (default)
- Autoboost Mode
- Autoboost Mode after "Mains Fail"
- Equalize Charge Mode
- Initial Charge Mode
2. The following system settings are set via Setnic
CSU:
- Charge voltage of each mode
- Current limit of each mode
- Autoboost time
- Total autoboost period
- Load voltage low
- Load voltage high
- Battery voltage low
- Battery voltage high
- Battery voltage low (urgent)
- Load voltage low (urgent)
|
3. The system information that displays on the LCD
display are as follows:
- System voltage and current of the operating
charge mode
- Battery charge / discharge current
- Battery temperature
- Load current
- Load temperature
- AC input voltage / current
- System information
- System operating status
- Alarm messages
4. A/D Calibration
We can calibrate the displayed values of analog
input signals of CSU via the functional keypads and
LCD to make them as same as the actual values.
The analog input signals contain the system's load voltage, load current, load temperature, battery voltage, battery current, battery temperature, ambient temperature, AC input voltage of each
phase and AC input current of each phase.
|
Download PDF 
